The Ins and Outs of Digging a Well

 Many people who do not live inside of a bigger city have to get their water for their household from a well. In fact, according to recent estimates, up to 45 million people have a well on their property. What are some of the ins and outs of well drilling?

Where should I drill?

You can drill a well on most any property! If you can get the appropriate drilling equipment to the site and you have the money (usually around $12,000), you should be able to start your well drilling. It’s also important to figure out what type of ground you’ll be drilling your well in. There is a big difference between hitting the water table in soft sand or gravel and hitting it in bedrock.

How does the actual well drilling work?

The first step of digging a well is normally to start with a round hole, about eight inches in diameter. Normally this hole is dug down about 20 feet into the bedrock and a six inch diameter “casing” is inserted. Mortar is then injected around that casing to keep water from coming from the soil into the well shaft. The shaft is then continued further down until the fractures in the bedrock allow for appropriate water to fill into the well. The “refill rate” is also measured – how fast the well refills after the water is pumped out. Five gallons per minute is considered the minimum standard. This often requires a well be dug down fairly deep into the bedrock. Once that “refill rate” is appropriate, an electric pump will be attached (this pump will have a power supply line and PVC pipe) and lowered down into the shaft to about 20 feet above the end of the well shaft. When purchasing an electric pump, the average horsepower you should look for is between three-quarters to two. Click here !

Why should I consider a well?

Even if you’re not going to use your well for drinking water, it is still a good idea to consider well drilling to help provide water for your lawn or other household uses, especially if your sewage and water are one combined bill. If you do use your well for drinking water, it must be tested and found clear of contaminants such as lead. You also must have a permit to have a well on your property in most states. This also lets you know any other specific statutes – like how far away from a septic system it must be and how deep it should be. A well can solve many problems for your property and also make your bills cheaper, depending on how much you use on a daily basis. Some farms and bigger properties can rack up quite the significant bills!

Before considering well drilling, it’s good to know more about both the process and any restrictions on the project you’re wanting to accomplish. A quality well should follow several standards and can add plenty of quality of your property is done the right way! Visit this site for more information : http://akronwelldrilling.com/